Kyocera TASKalfa 650c

1 TROUBLESHOOTING FOR THE HARDWARE
26 Clearing a Paper Jam
 Paper jam in the Saddle Stitch unit (optional)
The Saddle Stitch unit is inside the Saddle Stitch Finisher DF-810.
2
Separate the Finisher from the equipment.
1) Open the front cover of the Finisher when the Hole Punch Unit is not installed. Open the Hole Punch Unit cover
when the Hole Punch Unit is installed.
2) Pull the knob to unlock the Finisher.
3) Move the Finisher slowly placing your hands on the positions shown in the figure.
1
Remove the paper jammed in the paper exit side of
the Saddle Stitch unit.
3
Remove the jammed paper from the right side.
1
1
2
2
When the Hole Punch Unit is not installed
When the Hole Punch Unit is installed
When the Hole Punch Unit is not installed
When the Hole Punch Unit is installed