Chapter 1 PREPARATIONS
24
Energy saving mode
This equipment supports two energy saving modes; the Automatic Energy Save mode and the Sleep mode.
Automatic Energy Save
The equipment enters the Automatic Energy Save mode automatically after a specied period of time
*1
since its last use.
During this mode, “Saving energy – Press START button” appears on the touch panel.
Sleep mode
The equipment enters the Sleep Mode automatically after a specied period of time
*2
since its last use. In this mode, the
message on the touch panel goes o and the [ENERGY SAVER] button lights in green.
These modes are automatically cleared upon the reception of print data, Fax data, Internet Fax data or E-mails. They are
also cleared by pressing the [START] button.
*1 This period is set at 3 minutes for 55/55 ppm model, 5 minutes for 65/55 ppm model and 10 minutes for 75/65 ppm model by factory default.
*2 This period is set at 30 minutes by factory default.
Refer to the MFP Management Guide for changing the default settings noted above.
Press the [ENERGY SAVER] button on the control
panel.
To cancel the energy saving mode
Press the [START] button on the control panel. The sleep mode is cleared and the equipment will be ready for copying.
The sleep mode can be also cleared by pressing any button of [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and
[FAX].
The equipment can also be made to enter the sleep mode manually by means of the following procedure. In this mode,
the message on the touch panel goes o and the [ENERGY SAVER] button lights in green.
Note
For the European version
Contact your service representative to change the default settings noted above.
To Next Page
Loading...
