Kyocera TASKalfa 650c

3
2
1
4
5
Replacing Waste Toner Box
The procedure for replacing the waste toner box is as follows.
Replacing Waste Toner Box
45
1
3
2
1
Open the front cover of the Finisher, pull the knob to
unlock the Finisher, and then separate the Finisher.
2
1
3
2
Open the waste toner box cover and remove the
waste toner box.
2
1
3
Screw the lid on the opening of the waste toner
box.
2
1
4
Set a new waste toner box and close its cover.
2
1
5
Close the front cover of the Finisher and connect
the Finisher to the equipment.
Refer to the Troubleshooting Guide for details.
Note
The knob of step 1 is inside the cover of the Hole Punch Unit
when it is installed.