Job Accounting
4-2
Job Accounting Operation Procedures
Follow the procedures listed below to operate Job Accounting.
1 Press the Exposure Adjustment keys on both sides for 3 seconds while pressing the
Logout key.
Job Accounting: will be displayed.
2 Press or to select each of the mode displays.
NOTE: Refer to each of the following setting procedures and make the settings.
Each of the Modes can be selected by pressing the numeric keys.
3 After completing each setting, press or to select
00.Set Completed, and then press the OK key.
Department ID Code Registration
A Department ID Code of up to 8 digits can be entered.
1 Display Job Accounting. (Refer to Job Accounting Operation Procedures on page -2.)
2 Press or to select display 02.Register code,
and then press the OK key.
3 Enter the Department ID Code to be registered (up to a maximum of 8 digits) using
numeric keys.
NOTE: Number from 0 to 99999999 can be entered.
If a mistake is made during input it can be cleared by pressing the Stop/Clear key and the
value reentered.
4 Press the OK key.
The code that was input will flash on and off.
5 After confirming the code that was entered, press the OK key.
The display will return to that of Step 2.
NOTE: If an existing Department ID Code is attempted to be registered, an error will
occur and Already registered. will display in the message display. In this case, register a
different Department ID Code.
Job Accounting:
00.Set Completed
Job Accounting:
02.Register code
To Next Page
Loading...
