Appendix
Appendix-4
System Menu
The copier will enter the System Menu after warm up has been completed or when the Reset key has been
pressed. The settings automatically set for the copier in the System Menu are called the Default Settings. These
settings can be freely changed to match the usage of the copier.
System Menu Items
The following are the System Menu Items.
Change the settings as necessary in order to achieve the most efficient use of the copier. The factory default
setting is indicated by an asterisk (*).
System Menu Items Description Available settings
01.Copy Status Outputs the content of the Default Settings. ---
02.Language Set the language of the message display. [Inch specifications]
English*
Francais
Espanol
Japanese
Portugues
[Metric
specifications]
English
Deutsch
Francais
Espanol
Italiano
03.Image Quality Sets the manuscript image quality that will be selected
at the time the copier is turned on.
Text + P h D e n s .*
Photo Density
Text Density
04.Initial Dens. Sets the copy exposure at the time the copier is turned
on to Manual or Automatic.
There will be no display when Photo Density has been
selected in 03.Image Quality.
Manual*
Auto
05.EcoPrint Selects the initial value of the EcoPrint Mode when the
power is turned on. The initial value of the Eco Mode
can be set to on (Enable). Exposures will be lighter
and less toner will be consumed when the EcoPrint
Mode is used.
On: Enabled
Off: Disabled*
06.Density steps Changes the number of the adjustment steps for the
copy’s exposure. 0.5 - Setting this step enables even
finer adjustment of the exposure.
1 Step*
0.5 Step
07.Auto Density Adjusts the overall exposure of the copy when Auto
Exposure Mode is used.
1(lightest) to
7(darkest) (*4)
08.Text+Ph Dens. Adjusts the central exposure value for the copier’s
manual exposure (Text and Photo).
1(lightest) to
7(darkest) (*4)
09.Photo Density Adjusts the central exposure value for the copier’s
manual exposure (Photo).
1(lightest) to
7(darkest) (*4)
To Next Page
Loading...
