Troubleshooting
7-13
2
Open the left cover.
3
Remove any jammed original without tearing it.
Note If the original does happen to tear, remove any loose scraps from inside the document processor.
Failure to do so may cause another paper jam later.
4
Raise the paper feed unit A.
5
Remove any jammed originals without tearing them.
Note If the original does happen to tear, remove any loose scraps from inside the document processor.
6
Turn the dial as shown in the illustration to remove the
jammed original.
7
Close the left cover to its original position.
Reset all the originals and start copying again.
A
To Next Page
Loading...
