3-25
Enhancement device setup procedure > Unpacking enhancement device
[CONFIDENTIAL]
7
Cut off the carton board shown in red frame [A] to put a slope on.
8
Hang pins [B] on the backside of the slope onto bottom plate of skid then set the
slope [A].
9
Carry down DE-9100 from skid with the slope [A].
Do not lift up and carry the main unit by holding handles only.
Pay attention not to put your foot under DE-9100 in this work.
Do not leave the main unit under sunlight or outside to avoid from deforming the covers.
To Next Page
Loading...
