Kyocera Taskalfa Pro 15000c - Image Conveying Unit (Remove the Fixing Screws and the Plates)

2-12
The main unit setup procedure > Remove the transportation spacers
[CONFIDENTIAL]
(4) Image conveying unit (Remove the fixing screws and the plates)
1
Open the front right upper cover [A] and the front left upper cover [B].
2
Pull out the image conveying unit [C]. (Screw x4)
3
Remove the screw on the bottom of the image conveying unit [A]. (Screw x4)
(The screw has a tag [B])
IMPORTANT
In case of difficult to remove the screw, remove the screw [C] by sliding it to the aperture while slightly lifting the
front [A] or the rear [B] of the image conveying belt unit. (screw x4)
[C]
[C]
[C]
[C]
[A]
[B]
View after removing image conveying belt unit
* Screw sliding direction