Kyocera Taskalfa Pro 15000c - Print Position Adjustment (Print Position)

2-58
The main unit setup procedure > Adjustment
[CONFIDENTIAL]
(3) Print position adjustment (Print position)
U034 leading edge timing adjustment
1
Get into U034 Adj Paper Timing.
2
Select [Start Position].
• Select [Full (Shift)] for lead edge timing adjustment in full speed.
3
Press [System Menu/Counter] key.
• Set feed cassette or paper speed in Test Print (PG) mode.
• When the optional PF is installed, set the paper feeding source other than MP tray.
4
Press [Start] key to output the adjustment chart.
5
Press [System Menu/Counter] or [Stop] and get back to Full (Shift) screen.
• Select [1st Side] in case of first side adjustment and enter the value. [mm]
• Select [2nd Side] in case of second side adjustment and enter the value. [mm]
6
Change the setting value by using [+] [-] keys or the numeric keys.
• The image moves backward by increasing setting value and moves forward by decreasing the value.
• [Full (Shift)]: (Output from cassette, MP tray other than following setting) * With feed accelerating before registration
• [Full]: (Output to MP tray or selecting low paper feed speed) * Without feed accelerating before registration
• [Full (SRA3/12x18)]: * Print Full speed for SRA3/12x18 with duplex only
• [Half]: *Print for 1200dpi or IJ mat paper
One side
or
First side of duplex
Second side of duplex
Full(Shift)
U034
01
02
1st Side
2nd Side
-1.50
0.00
Full
U034
01
02
1st Side
2nd Side
-1.50
0.00
Half
U034
01
02
1st Side
2nd Side
-1.50
0.00
21.5mm