Kyocera Taskalfa Pro 15000c - Page 29

2-13
The main unit setup procedure > Remove the transportation spacers
[CONFIDENTIAL]
4
Pull out the image conveying unit [A] by holding handles [B] and [C], and place it on a
table.
• Take care not to damage the electrical components.
5
Remove the right side bracket [B] from the image conveying unit [A]. (Screw x7)
6
Remove the left side bracket [B] from the image conveying unit [A]. (Screw x8)
IMPORTANT
Pay attention when handling the print conveying belt unit, the lift wire might come off if lifting up the lift plate
from the bottom.
[A]
[B]
[C]
[C]