3-104
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
11
Check height and level of main unit and DE-9100.
1 Check the height.
Check if panel line (black and white) align DE-9100 and main unit. If the border of black and white, then insert
pin [B] on connection plate [A] into hole [C] of DE-9100 and connect DE-9100 to main unit. Check the position
of pin [B] diameter [D] and hole [C] height [E].
• OK: Outline [D] of pin [B] is in between hole [C] height [E].
• NG: Outline [D] of pin [B] is out of hole [C] height [D].
• Height adjustment is required when the border is not aligned.
NG NG
OK
[C]
[B]
[E]
[E]
[D]
[D]
[E]
[D]
[B]
[C]
b
[D]
[E]
DE-9100
Main Unit
[A]
To Next Page
Loading...
