Kyocera Taskalfa Pro 15000c - Page 237

3-159
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
65
Remove the front right cover [A] (screw x3).
66
At the front right corner, remove the screw of the lock bar [A] (Screw x1), and pull the
lock bar toward you until it stops. Use this screw in Step 68.
67
Slowly push the high capacity stacker [B] against the left side of the upstream unit so
that the lock bar [A] is directly and squarely under the arms of the joint bracket [C].
[A]
[B]
[A]
[C]