3-162
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
74
Set the four leveling shoes [A].
75
If large media is used, install the accessory support tray [A] on the proof tray.
The support tray is used for thick paper or large envelopes (B4 / K2 (envelopes) or more), to prevent the trailing
edge of paper stuck on the proof tray from getting lifted and the proof tray being detected as full too early.
Installation (Roll-Away Cart)
76
Align the studs on the tray cart base [A] with the holes in the brackets of the paper
tray [B]. Set the holes over the studs.
• Place a level on the top of the unit and then adjust the height with leveling shoes so that the unit is level left-
to-right and front-to-back.
To Next Page
Loading...
