Kyocera Taskalfa Pro 15000c - Page 295

3-217
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
Punch entry registration correction
1 Select [Finisher], [Punch Regist] in Maintenance mode U246.
2 Select setting values.
Increase the value for the copy sample [A] (Skewing).
Decrease the value for the copy sample [B] (Z shape folding).
3 Press [Start] key to set the setting value.
Punch position adjustment
1 Select [Finisher], [Punch Feed] in Maintenance mode U246.
2 Select setting values.
Increase the value in case that position is shorter than standard [C].
Decrease the value in case that position is longer than standard [C].
3 Press [Start] key to set the setting value.
<Standard [C]>
Metric: 13 mm, Inch: 9.5 mm
Punch position center adjustment
1 Select [Finisher], [Punch Width] in Maintenance mode U246.
2 Select setting values.
Increase the value in case that position is off to the front.
Decrease the value in case that position is off to the rear.
3 Press [Start] key to set the setting value.
<Standard>
Metric: [D]=80(+/-)0.5 mm, [E]=40(+/-)2 mm
Inch: [D]=2.75+/-0.5”, [E]=1.375+/-2”, [F]=4.25+/-0.5”
[A] [B]
[C]
[E]
[D]
[F]
[F]