Kyocera Taskalfa Pro 15000c - Page 304

3-226
Enhancement device setup procedure > Optional device installation
[CONFIDENTIAL]
3
Put USB cable [C] through to the pole [D]. Put USB cable through to the pole bracket
[B]. Put the pole into the bracket matching the position showed in [E] and secure with
2 screws [A].
4
Hook up USB cable [B] and the body unit [A] and secure with the plastic band [C]. Cut
off extra part of the band [C].
IMPORTANT
Tighten at thinner part [D] of USB cable [B] with band [C].
[C]
[B]
[D]
[A]
[A]
[A]
[B]
[E]
[B]
[D]
[A]
[B]
[A]
[B]
[C]
[C]
[C]
[B]
[D]