6-2
Machine transportation after setup > Procedure for the main unit transportation (floor to floor)
[CONFIDENTIAL]
6
The number of clogged nozzle come up by scanning the chart.
7
Select [Waste Ink Pump] in U030 Motor operation check and press [start] key to start
the pump. Press [stop] key to stop.
Perform the pump operation min.60 sec. and max.90 sec.
Collect the waste ink on the tray to the waste ink tank.
8
Turn the power switch off and cap print head nozzle.
It may take about 3 minutes until power off.
9
Remove the front paper width guide [A] in the direction of the arrow. (Screw x1)
10
Remove the rear paper width guide [B] in the direction of the arrow. (Screw x1)
When ink non-ejection has occurred
Ink ejection confirmation chart
To Next Page
Loading...
