6-18
Machine transportation after setup > Procedure for the main unit transportation (Truck transportation)
[CONFIDENTIAL]
20
Remove the image conveying unit [A] holding handles [B] and [C], and place it on a
table.
• Take care not to damage the electrical components.
21
Hold and attach the protective cap [A] in the direction of arrow.
Clean with deionized water before installing. (See page 2-35)
22
Insert the pin [C] of the protective cap into the positioning hole [D] on the rear frame.
Then, tighten 8 screws [B] in the protective cap [A].
(Use stubby driver to tighten screws since it is narrow.)
• Please make sure not to touch the print head by the protective cap.
23
Tighten 2 screws.
Pay attention when handling the image conveying unit, the lift wire might come off if lifting up the lift plate from
the bottom.
To Next Page
Loading...
