2-40
The main unit setup procedure > Ink initial supply (Set up flow)
[CONFIDENTIAL]
10
(Display: MANU0102) Remove the bracket rear cover [A]. (Screw x2)
Pushdown 10 couplings [B] and connect to the main unit.
• Select [Execute] after completing the steps, then press [Start] key to continue.
11
(Display: AUTO0103) Perform the ink and the cleaning liquid circulation.
• Select [Execute] and press [Start] to run the job.
• If the error code is displayed, check the list and perform necessary action. (See page 5-15
)
Then select [execute] and press [start] to return step 9.
If service call error C2260 occurs, check the position of the unit with the following link and shift it to the Page
position.
C2260: Head maintenance sensor error (See page 5-8
for the corrective action of service call)
To Next Page
Loading...
