38
available. Battery is not supplied by manufacturer.
1. Hook up a 120-volt AC power cord to recreational vehicle for
converter operation.
2. Use 12 volt power through the tow vehicle to the recreational
vehicle’s as third choice.
TRAILER SET-UP REQUIREMENTS - GENERAL
Note:
1. Before operating the slide-out room, level the trailer front-to-rear
and side to side.
2. Extend all stabilizer jacks to make solid contact with the ground
and/or on solid blocks. Placing stabilizer jacks onto a hard
surface allows the coach to remain square and assure a good
weather tight seal between the room and trailer sidewall.
BELOW FLOOR SLIDE SYSTEM
Mechanical Components.
Below floor slide-out mechanism consists of a track welded to a
frame cross member, matching with a gear on drive shaft assembly.
Motor and gear box are mounted on a ram attached to bracket, to
move room in or out Operation is identical on both systems. As
motor turns, a ram moves the gear on the track. A cross shaft, front
to rear ram connects the second ram, moving the opposite end of
slide, may be inside of main rail or just outside. Mechanism
operates the same, flush or standard floor.
ABOVE FLOOR SLIDE OUT (ALL BRANDS AND TYPES)
This system operates on an inside ram assembly on a track moved
by a cog gear. Ram is attached to the floor and side wall with a
moving track attached to the slide-out. On larger slides, two (2)
rams will be used with cross shaft connecting the 2 rams. A steel
frame carriage style is used on some models, doing same function
generally as a 12’ slide. Access to these components is inside of
coach, under slide floor.
BEDROOM SLIDE OUT
This slide assembly is placed and attached to the floor of the front
bedroom slide. This includes all hardware, motor gears, shaft, track
and framework. Two rollers are also attached to sidewall at opening
point, to give ease in slide out movement, in and out.
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...