39
Operational Switch, Three Position Switch
OPEN: Hold operation switch in OUT position
until room seals tightly on the exterior of the unit.
DO NOT distort or bend the exterior flanges or
interior fascia by holding the switch in the “ON”
or “OUT” position.
CLOSE: To retract, reverse the procedure and hold button in
the IN position until the room is fully inside with gaskets sealing to
the outer wall. It takes about 20 seconds to move the slide in or out.
KZRV does NOT require or suggest blocking, supports, jacks,
etc., to be used under slide outs during extended normal use.
Should you place blocking under slide, you may distort water seal on
sides and top.
When opening slide room, DO NOT over-extend. Fascia board can be distorted,
loosened or bent from correct position
CAUTION
!
Stand clear of the room’s interior path and verify that the room’s exterior path is
clear before extending or retracting the room.
WARNING
!
♦ Always make sure that the trailer is level before operating the slide-out room.
♦ Always make sure there are no obstructions blocking the path of the room when it
is moving.
♦ Always make sure that the room path is clear of people and objects before operat-
ing.
♦ Always keep away from the slide rails under the coach when the room is in mo-
tion.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY
OR DEATH.
WARNING
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
