46
C. During the water tank filling
process, check the monitor panel
for filling process. (if applicable).
S=Siphon hose– used to:
1. Winterize water system.
2. Sanitize water line system.
P=Pump 12 volt DC – To supply
coach with water when city
water is not available.
F=Filter-Cap to be removed to
clean out or replace.
G=Gravity water fill-To fill tank.
C=City water fill-To fill lines.
T=Tank –To hold water.
V1= Valve to be opened ONLY
when using siphon hose as
listed above.
V2= Valve to be open to draw water from supply tank, closed
when siphon hose is used.
12-Volt Demand Pump
When water is desired and you are not hooked up to city water, your
tank will be your supply. On your monitor panel is a switch to turn
on the 12-volt demand pump. Energy for the pump is supplied by
the auxiliary battery or converter. The pump will self-prime when
started, supply water, and continue to run until approximately 40
pounds of pressure is achieved. When pressure drops to 20
pounds, pump will restart. Some cycling in pump may occur. A
check valve is built within the pump to prevent water from flowing
into the supply tank.
The pump has a small filter attached on the “in port “ side to prevent
any foreign matter from entering the pump. You need to annually, or
DO NOT leave tank unattended while filling, as an over filled tank will built
pressure, causing tank to crack, rupture, and leak or even damaging sup-
ports holding it in place.
CAUTION
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
