54
FLUSH SYSYTEM—( Standard on some units, optional on
others )
The flush system is designed and built to rinse the waste holding
tank, AFTER waste tank has been drained completely of water and
solids.
1. Attach a fresh water source to the connection marked “Sewer
Tank Flusher”. Be sure termination valves are open on all
tanks.
2. Open valve to release water into tank for rinsing and cleaning of
your waste water holding tank.
3. Rinse for several minutes to remove any foreign matter from
tank, and probes.
Remember the moisture content may give you a false reading on
your monitor panel indicating it is full. Allow time to dry out tank or
recharge for next usage.
Maintenance for Holding Tank
The following maintenance is recommended by our holding tank
suppliers to keep your tanks clean and keep the probes free of
debris and build-up.
Gray (Waste-Water) Tank. Fill tank with 8-10 gallons of warm water.
Add a degreaser such as a citrus cleaner or Dawn dish soap. Leave
solution in tank while you are traveling. Rinse and drain tank.
Black (Sewer) Tank. Fill tank with 8-10 gallons of water. Add one
bottle of drain cleaner, such as Drano or Liquid Plumber. Leave the
solution in tank while traveling. Rinse and drain tank.
Sewer Tank Flusher– DO NOT use the flush valve unless the termination
valve is open. Can result in an unsanitary condition leading to illness or
personal injury
CA U TION
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
