L-Acoustics A15i Series User Manual

Rigging procedures
Rigging procedures
General principles
Because of the highly-modular nature of the rigging system, not all possible congurations are described in the rigging
procedures. This introduction provides general principles applicable for all congurations.
References
For information on radial congurations with A15i-LIFT, refer to APPENDIX A: Authorized congurations with A15i-LIFT
(p.111).
For information on wall-mounted or ceiling-mounted congurations with A-U15i, refer to APPENDIX B: Congurations with
A-U15i (p.113).
To know the site angle of the rst enclosure secured on A15i-TILT, refer to Realized site angles (with A15i-TILT at the rear)
(p.86).
Securing rigging plates on an enclosure
• Follow the curvature of the front of the enclosure when securing the rigging plates.
• Make sure that the inserts for the screens are accessible.
Driving screws
Do not fully tighten the screws unless otherwise instructed.
Follow the indicated torque when tightening a screw.
A15i owner's manual (EN) version 1.0 49

L-Acoustics A15i Series Specifications

General

Brand	L-Acoustics
Model	A15i Series
Category	Speakers
Language	English