EasyManua.ls Logo

La Marzocco LEVA X - Operation and Coffee Preparation; Initial Setup and Heating

La Marzocco LEVA X
98 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
22
4. Machine Operation and Coffee Preparation
IMPORTANT
To improve the avor of the espresso, the
temperature of the water in the coffee boiler
and therefore of the groups may eventually
be raised or lowered via the digital display
(please consult the Software Programming
Manual for detailed instructions).
CAUTION
Never remove the lter holder
when water is being delivered.
This operation can be extremely
dangerous since the high
pressure built-up inside the
blind lter would spray out hot
and slightly caustic water, which
may cause severe burns. The
Coffee Boiler contains water at
elevated temperature. Water
temperature over 125°F / 52°C
can cause severe burns instantly
or death from scalding.
WARNING
The machine must not be dipped
in, nor splashed with, water in
order to clean it. For cleaning
operations, please follow the
instructions listed below very
carefully.
WARNING
This machine is designed only
for preparing coffee and hot
drinks.
1) Removing the portalter when it is under
pressure
You might have to remove the portalter
while it is subject to the pressure exerted
by water.
This happens in the following two cases:
The portalter has been erroneously
lled with an excessive dose of coffee
powder, obstructing the water/coffee ow.
A ushing with a blind portalter is
under way.
In these cases you need to operate the
control lever to lift the piston by a few
millimetres, to counteract the pressure
exerted by the spring. Pressure will drop to
the pre-infusion value.
WARNING: pressure will not drop to zero.
Now you can slowly remove the portalter,
driving the piston downward by means of
the lever.
WARNING: hot water will inevitably ow out,
so:
WARNING
N
ever remove the portalter if:
• delivery is not over
• the pressure read on the relevant
pressure gauge is higher than the
pre-infusion value
• the pressure read on the analogue
or digital pressure gauge exceeds
zero.
To remove the portalter in one
of the previous cases follow the
indications contained in paragraph
“Removing the portalter when it is
under pressure”.

Table of Contents

Related product manuals