EasyManua.ls Logo

La Marzocco LEVA X - Maintenance Schedule; Mandatory Maintenance and Check-Up Operations

La Marzocco LEVA X
98 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
33
8. Mandatory Maintenance and Check-up Operations
▪ Replace group gaskets
▪ Replace diffuser screens
▪ Clean auto-fill probe
▪ Check vacuum breaker for
proper operation
▪ Inspect water inlet valve
▪ Check brew temperature
▪ Checking the pre-infusion and
delivery pressure
▪ Check all switches for proper
operation
▪ Check/note water hardness
(Water quality must be within the
range of parameters specified in
the chapter on Installation,
otherwise warranty is voided)
▪ Check filter basket condition
▪ Expansion valve inspection
▪ Spring stem inspection
▪ Cam inspection
▪ Check for cylinder complete
saturation
These operations are in addition to the Maintenance and Periodic Cleaning Operations as specied in Chapter 6.
The following maintenance and check-up operations sould be carried out by a qualied technician.
The time required for the periodic maintenance is determinated by the quantity of daily work and/or coffee consumption.
N.B. These periodic maintenance operations are not covered by warranty.
▪ Check the condition of the inside of boilers and if necessary rinse out with a proper cleaning product allowed for food and beverage
appliances.
EVERY THREE/FOUR MONTHS
EVERY 3 YEARS (in addition to the above)
▪ Replace portafilter baskets
▪ Inspect vacuum breaker
▪ Inspect electrical wiring
condition
▪ Inspect boilers safety switches
▪ Replace over-pressure valve
(safety valve)
▪ Accurate control of the
tightness at 2,4Nm of each
cable on the terminal block
▪ Replacement of piston seals
▪ Check for tightness of the lever
mechanism screws
Version S:
▪ Overhaul of steam taps
Version X and 90:
▪ Inspection of steam proportional
valve
▪ Replacement of piston stem
seals
▪ Replacement of spring stem
guide rings
▪ Replacement of cam wheel
▪ Replacement of lever mechanism
rollers
EVERY YEAR (in addition to the above) EVERY 2 YEARS (in addition to the above)

Table of Contents