124
16, 17, 18, 19, 21. Until the num-
ber of cell with stored radio station
appears on the display and audio
signal heard (if sound confirmation
for button) confirming that radio sta-
tion has been successfully stored.
Note. Station storing by user is not
available for FMAS range.
3.5 Listening to previously
found radio stations
3.5.1 Selection of radio station
stored within memory is performed
by brief pressing of 14, 16, 17, 18,
19, 21 (Fig. 2) buttons.
3.5.2 Upon brief pressing of
RADIO button (pos. 22) range of
received waves will be switched as
follows VHF – FM1 – FM2 – FM3 –
FMAS (this range will be available
after searching within combined
VHF-FM) – AM1, by loop.
Note. If CB range is switched off in
user’s settings, then modes will be
switched in the following sequence VHF –
FM1 – FM2 – FM3 – FMAS (this Range is
available after search within combined
VHF-FM range only).
3.6 RDS function
3.6.1 RDS (Radio Data System) is
a multi-purposed standard designed
for transferring information mes-
sages via channels of transferring
modulation of broadcast within VHF
range.
3.6.2 Radio has RDS functions
provided in Table 3.
4. Audio mode
4.1 Playing back audio files
4.1.1. Switching to the audio files
listening mode can be carried out in
the following ways:
– by connecting of SD-card;
– by connecting of USB-drive;
– by pressing AUDIO (Fig. 2, pos. 20).
Note. Switching to AUDIO mode will
not happen if the receiver is in CALL
mode.
4.1.2 Correct connection is
described in Appendix В.
4.1.3 In this mode in the upper line
(Fig. 4, pos. 3) the number of folder
or track title and current track time is
indicated. In the lower line – the track
name → file name → folder name →
artist name (selection is made by
short pressing of DISP button (pos.
9). If the information is larger than 16
symbols, the line will be cycled.
ATTENTION!
The radio plays back audio files
in MP3 и WMA formats.
4.2 Playback start/stop
4.2.1 To start the audio files play
back you should:
– install SD/USB with audio files;
– press button
1«
4
I» (Fig. 2, pos. 21).
Note: Playback is automatically stops
after pressing MUTE button (Fig. 2, pos.
3) or when incoming phone call is
received and automatically continues
after pressing or turning encoder handle
(Fig. 2, pos. 6), or after end of phone call.
4.3 Displaying of additional
information (if any)
4.3.1 Press button 2 TAG (Fig. 2,
pos.19) – the additional information
about the current file will be dis-
played (singer name, album title or
song title) with МР3 extension.
4.3.2 To stop displaying this infor-
mation press again 2 TAG (Fig. 2,
pos. 19).
To Next Page
Loading...
Need help?
General
