LIGHT ALARM SWITCH
I (Fig. 34) – neutral position. The
dipped beam is on if the headlight
beam is switched on with the exterior
light switch.
II – left turn indicators are
switched on. Non-fixed position.
III – left turn indicators are
switched on. Fixed position.
IV – right turn indicators are
switched on. Non-fixed position.
V – right turn indicators are
switched on. Fixed position.
VI – pull, light signaling. Main
beam is switched on, regardless of
the exterior light switch position.
Non-fixed position.
VII – push, main beam is on, if
the headlight beam is switched on
with the exterior light switch. Fixed
position.
WIPER SWITCH
The windshield wipers are turned
on by changing the key in the ignition
starter switch to position I.
I (Fig. 35) – neutral position.
Window wipers and washers are
switched off.
II – intermittent operation of
the windshield wiper is switched
on. Non-fixed position.
III – intermittent operation of
the windshield wiper is switched
on. Fixed position.
IV – low speed of the windshield
wiper is switched on. Fixed position.
V – high speed of the wind-
shield wiper is on. Fixed position.
VI – pull, windshield washer is
switched on. Non-fixed position.
VII* – push, rear window wiper is
switched on (in the design vari-
ant). Fixed position.
VIII* – push, rear window wiper
and washer are switched on (in
the design variant). Non-fixed
position.
In the intermittent operation the
wiper strokes its blades once per
several seconds at a constant inter-
46
Fig. 35. Wiper leverFig. 34. Light alarm switch lever
* For «liftback» and «universal» body vehicles; it is not used in «sedan» body vehicles.