REMOTE CONTROL SYSTEM
(in the design variant)
The power pack remote control
system is designed for:
– remote locking (unlocking) of
door locks with the vehicle protection
mode parallel activation (disabling);
– all door locks locking by turning
the key in the driver's door lock;
– all door locks locking (unblock-
ing) by the key from the vehicle pas-
senger compartment;
– alarm system activation during
violation of the vehicle protection
zones;
– alarm system remote control
disabling or after ignition starting
with the key.
For operation it is necessary to
activate (train) the remote control
panel (Fig. 2) in the vehicle composi-
tion by using the training code key
(see Section «Immobilizer»). After
training, the remote control panel is
also an immobilizer working code
key and serves to unlock the engine
start inhibit mode. System training
and operation of the system can be
carried out simultaneously with 4
remote controls.
ATTENTION!
Selling of the vehicle equipped
with remote control system, with-
out remote control panel training,
is not allowed. The remote control
panel training procedure must be
carried out at the vehicle pre-
sales training points or at the cer-
tified SSNEs in the vehicle owner
obligatory presence. In case the
vehicle owner refuses to carry
out this procedure, the relative
record must be recorded in the
vehicle log book signed by the
sales dealer, affixed with the
company's seal and the owner
attesting signature. No claims for
remote control system operation
quality are accepted, if the vehi-
cle owner of the vehicle loses the
training code key.
7
Fig. 2. Remote control panel
To Next Page
Loading...
Need help?
General
