The positions for the dipped beam
hydraulic adjuster handle (Fig. 32b)
depending on the vehicle load state:
0 – the driver or the driver + the
front passenger;
1 – the driver + 4 passengers or
the driver + the load in the luggage
compartment;
2 – the driver + 4 passengers +
the luggage in the luggage compart-
ment.
If necessary, adjust dipped beam
by turning the handle 3 to align the
handle mark with one of the marks
on the scale corresponding to the
vehicle load state.
When setting the electrical
adjuster handle to position outside of
scale marks, asynchronous passing
of dipped beam of the left and right
headlight units is possible, which is
not a defect.
Warning
Correct adjustment of the
beam tilt angle reduces the daz-
zling of oncoming traffic drivers.
To avoid poor lighting of the
roadway do not set the handle to
end position counter-clockwise.
Rear fog lights switch. To switch
on the fog lights, press key-button 2
with the dipped beam on. Re-pressing
of the button turns off the fog lights.
Front fog lights switch (in the
design variant). To switch on the
fog lights, press switch button 4 with
the tail lights on. Re-pressing of the
button turns off the fog lights.
In the design version the vehicle
has function «Illuminated track». With
ignition is off it is necessary to open
the driver’s door. Switch the main
beam on by holding the light alarm
switch lever in non-fixed position,
after the lever released the dipped
headlights will be switching on for 40
seconds.
With «Illuminated track» function
on it is possible to switch it off by re-
switching the main beam on holding
the light alarm switch lever in non-fixed
position or by ignition switching on, in
case the operating time is not up.
45
Fig. 32b. Dipped beam headlights
adjuster
Warning
When driving in conditions
requiring fog lights or fog lamps,
with the automatic control sys-
tem of exterior lighting on (exte-
rior light switch is in position –
in the design variant) the exterior
light switch must be changed to
position or .
RAIN AND LIGHT SENSOR
In the design variant the vehi-
cles are equipped with combined
rain and light sensor located on the
windshield behind the rear view mir-
ror (Fig. 33).
Fig. 33. Rain and light sensor