TRUNK LID
The trunk lid/tailgate is unlocked
by turning the key in the lock cylinder
(Fig. 25a) counterclockwise (it is
locked in a clockwise direction).
Luggage compartment in «liftback»
vehicle is separated by folding rack 3
(Fig. 25b).
In the design variant the trunk
lid/tailgate is opened by pressing the
button in the remote control
console or from the passenger com-
partment with the switch located on
the left side of the instrument panel
(Fig. 26a) under illumination control
unit. For correct operation of «but-
ton-lock» system in «standard» and
«norm» versions you shall press the
trunk lid/tailgate button for not less
than 1-2 seconds. In the design
variant the trunk lid/tailgate is
opened by once or double pressing
the button.
With the trunk lid/ tailgate opened
and external lights switched on the
luggage compartment is lighted with
the lamp.
In the design variant, the inside
handle (Fig. 26b) shown by arrow is
provided for closing the trunk lid. To
close the trunk lid from position A,
take the inside handle and pull the
trunk lid down to position B. Then
lower the inside handle and go on
with closing the trunk lid by pressing
against its external (horizontal) part.
32
Fig. 25a. Opening the luggage
compartment
Fig. 26a. Trunk lid latch actuator
switch (in the design variant)
Fig. 26b. Trunk lid
inside handle (in the design variant)
Fig. 25b. Tailgate opening
To Next Page
Loading...
Need help?
General
