Lainox Naboo boosted User Manual

- 92 -
22 • SELF-DIAGNOSIS AND ERRORS GUIDE
22.1 •
When the oven is turned by pressing
knob for 3 seconds, an electronic check
of the main functions will automatically be
performed by the device. Once the self-
diagnosis has been performed, if the oven
proves to be in perfect operating conditions,
the cooking chamber temperature display
will show the real temperature of the
chamber and the cooking mode Leds will
flash. Cooking parameters can therefore be
set.
22.2 • If on the other hand the oven detects
errors, these will be shown on display. The
visualisation of errors is very important in
the event technical support is required, as
this value provides information about the
type of error. The message on the display
is accompanied by an acoustic signal that
lasts for 5 seconds, which is repeated every
minute until the oven is turned off.
A10
Fault in cooking chamber temperature probe,
immediately turn off the oven and call the technical
support service.
A11
Fault in boiler preheating probe, the oven can only work
in convection model, Steam and Combi modes cannot
be activated. Call the technical support service.
A12
Fault in vapour condensation temperature probe. The
vapour condensation is working continuously, the oven
however, can work under strict observation (greater
water consumption), until the technical support service is
called out
A13
Fault in core probe. The oven may still be used in timed
mode until the technical support service intervenes, but
without using this accessory.
A04
This means that no water is reaching the oven; it is
therefore necessary to check that the tap is open and
that there is water in the network. If the lack of water
depends on the network, inform the supplying entity. If
on the other hand there is water in the network, call the
technical support service. In the meantime, the oven can
be used in convection mode.
A11
Intervention by motor's thermal protective device.
Immediately turn off the oven and call the technical
support service.
A02
Intervention by the cooking chamber safety thermostat.
Immediately turn off the oven and call the technical
support service.
A03
Intervention by the boiler safety thermostat, immediately
turn off the oven and call the technical support service.
A07
There is overheating in the electrical components
compartment. The oven can still be used under careful
observation until the technical support service intervenes.
MESSAGES
The main error messages are:
90037400rev00

Lainox Naboo boosted Specifications

General

Brand	Lainox
Model	Naboo boosted
Category	Oven
Language	English