4 cHAPTER 1: Introduction
Model 335 Temperature Controller
1.1.4 Configurable
Display
The Model 335 offers a bright, vacuum fluorescent display that simultaneously dis-
plays up to four readings. You can display both control loops, or if you need to monitor
just one input, you can display just that one in greater detail. Or you can custom con
-
figure each display location to suit your experiment. Data from any input can be
assigned to any of the locations, and your choice of temperature sensor units can be
displayed. For added convenience, you can also custom label each senor input, elimi
-
nating the guesswork in remembering or determining the location to which a sensor
input is associated.
D Two Input/Output Display with Labels: Standard display option featuring two
inputs and associated outputs.
D Custom Display with Labels: Reading locations can be user configured to accom-
modate application needs. Here, the input names are shown above the measure-
ment readings along with the designated input letters.
D Intuitive Menu Structure: Logical navigation allows you to spend more time on
research and less time on setup.
1.1.5 Model 3060
Thermocouple Input
Option
The field installable Model 3060 thermocouple input option adds thermocouple
functionality to both inputs. While the option can be easily removed, this is not neces
-
sary as the standard inputs remain fully functional when they are not being used to
measure thermocouple temperature sensors. Calibration for the option is stored on
the card so it can be installed in the field and used with multiple Model 335 tempera
-
ture controllers without recalibration.
BSensor input connectors
CTerminal block
(analog outputs and relays
DUSB interface
E IEEE-488 interface
F Line input assembly
GOutput 2 heater
HOutput 1 heater
I Thermocouple
option inputs
FIGURE 1-2 Model 335 rear panel
FIGURE 1-3 Displays showing two input/output display with labels, custom display with labels and the intuitive menu structure
To Next Page
Loading...
