- 4 -
1 General remarks
1.1 Allow for compliance with the Equipment Safety Act
The Equipment Safety Act provides the following:
Comply with the operating instruction!
Proceed as instructed by this technical documentation
(Printed matter no. DLT 7620-04D-0001).
Make sure to only use the equipment for the purpose as described herein.
Operation to be carried out by qualified staff only. The equipment may only be oper-
ated and maintained by persons capable of properly doing so based on their knowl-
edge and qualification level.
Liability for proper functioning of the equipment will be transferred to the owner
or operator by law.
Liability for proper functioning of the equipment will be transferred to the owner or op-
erator by law if the equipment is improperly operated, maintained or repaired by per-
sons that do not have the knowledge required, or if the equipment is handled in a way
not complying with the purpose intended.
LAMTEC GmbH & Co KG shall not be held liable for any damage caused by non-
compliance with the instructions given in this manual. The warranty and liability condi-
tions of LAMTEC GmbH & Co KG shall not be extended by the instructions as given
hereinafter.
Any reference to laws, regulations and standards shall be subject to the legislation of
the Federal Republic of Germany.