11
3 Product Description
3.4 Selection Criteria
The Flame Monitor is particularly designed for mono-burner plants. It can be used with the fol-
lowing fuels:
• Oil
• Gas
• Biomass
• Solids (wood dust, etc.)
• chemical and other waste products
• or a combination of these
Selection Criteria Spectrum and Frequency
The spectral sensitivity of the flame scanners determines their suitability for specific fuels.
NOTICE
LAMTEC guarantees that the flame sensor is in perfect working order but cannot offer any
guarantees if it is used improperly.
Note the specific requirements of your plant when selecting the flame sensors. We will be
pleased to answer any questions you may have in relation to LAMTEC products.
Selection criteria fuel:
The following table provides an overview:
Type Sensor Sensi-
tivity
Spectrum [nm] Sight
angle
approx
Preferred Area of Application/Fuels
FFS07,
FFS07 Ex,
FFS08
UV-1 +
o
260 ... 400 nm 8° • Oil
• Gas
UV-4 ++ 215 ... 360 nm 8° • Oil
• Gas
• Special gases such as refinery gas,
blast furnace gases and hydrogen
--
FFS07,
FFS 07 Ex ,
FFS08
IR-1
++
1000 ... 2500 nm
60°
• Oil
• Gas
• Furnaces with a high level of flue-gas
recirculation
• Yellowish waste gases without UV
radiation
To Next Page
Loading...