Configuration Parameters Configuration
7-4
Configuration Parameters
After entering Setup Mode (confirm by pressing Enter), you can configure the parameters
by entering one of the numbers on the Change Setup Menu, or you can confirm default
values by pressing Enter. Be sure to store the new configurations when you are finished.
The Device Server will then perform a power reset.
Figure 7-4: Setup (Configuration) Mode Screen
Serial Number 5411011 MAC address 00:20:4A:54:10:03
Software version V4.30 (001206)
Press Enter to go into Setup Mode
*** basic parameters
Hardware: Ethernet Autodetect
IP addr 192.168.1.10, gateway 192.168.001.001,netmask
255.255.255.000
***************** Security *****************
Telnet setup is enabled
TFTP download is enabled
Port 77FEh is enabled
Web setup is enabled
Enhanced password is disabled
Encryption is disabled
***************** Channel 1 *****************
Baudrate 9600, I/F Mode 4C, Flow 00
Port 10001
Remote IP Adr: --- none ---, Port 00000
Connect Mode : C0 Disconn Mode: 00
Flush Mode : 00
Change Setup : 0 Server configuration
1 Channel 1 configuration
6 Security
7 Factory defaults
8 Exit without save
9 Save and exit Your choice ?
To Next Page
Loading...
Need help?
General