Serial Timing Hardware
9-1
9: Serial Timing
Hardware
The signal condition and rise and fall times on the serial input and output lines for the
CoBox-Micro, CoBox-Mini, and CoBox-Mini100 conform to CMOS input/output
standards. For protection, a 220 Ohm resistor is used in series.
For the CoBox UDS-10B serial timing, refer to the RS232, RS422/485 standards that are
applicable (see MAX 232 chip set requirements).
For further information, visit Advanced Micro Devices (AMD) on the web and refer to their
documentation. Read the Am186ES/Am188ES data sheet and User’s Manual.
To Next Page
Loading...
