Serial Channel (Port) Configuration Configuration
7-6
DHCP Naming
The DHCP name of the Device Server can be changed. The default name of the Device
Server is Cxxxxxx, where xxxxxx is the last 6 digits of the Mac address. This option can
be changed to LTXdd, where 0.0.0.dd is the IP address assigned (dd should be a number
between 1 and 99). For example, by setting the IP address to 0.0.0.5, the resulting DHCP
name is LTX05.
A DHCP name of the customer’s own choosing (up to 8 characters) can also be designated.
This option can be set in the server configuration menu.
Figure 7-5: Server Configuration Menu
Serial Channel (Port) Configuration
Select 1 to configure the Device Server’s channel-specific parameters.
Baud Rate
The Device Server and attached serial device, such as a modem, must agree on a speed or
baud rate to use for the serial connection. Valid baud rates are 300, 600, 1200, 2400, 4800,
9600 (default), 19200, 38400, 57600 (only on AMD-based hardware platforms), and
115200 bits per second.
Change DHCP device name (LTRX) ? (N) Y
Enter new DHCP device name : LTRXYES
To Next Page
Loading...
