Monitor Mode Troubleshooting
B-2
Note: All commands must be given in capital letters, with blank spaces
between the parameters.
Table B-1: Monitor Mode Commands
Command Command Name Function
DL Download
Download firmware to the
Device Server via
the serial port in hex format
SF x.x.x.x Send Firmware Send firmware to Device Server with IP address
x.x.x.x
VS x.x.x.x Version Query software header record (16 bytes) of
Device Server with IP address x.x.x.x
GC x.x.x.x Get Configuration Get configuration of Device Server with IP
address x.x.x.x as hex records (120 bytes)
SC x.x.x.x Send Configuration Set configuration of Device Server with IP
address x.x.x.x from hex records
PI x.x.x.x Ping Ping Device Server with IP address x.x.x.x to
check device status
AT A R P Ta b l e
Show the
Device Server’s ARP table entries
TT TCP Connection
Table
Shows all incoming and outgoing TCP connec-
tions
NC Network Connection
Shows the
Device Server’s IP configuration
RS Reset
Resets the
Device Server’s power
SI
xxx.xxx.xxx.xxx:yyy.
yyy.yyy.yyy
Send/Set IP Address Remotely assign an IP address to a Device Server,
where xxx.xxx.xxx.xxx is the IP address, and
yyyy.yyy.yyyy.yyy is the two-part identification
number at the bottom of the label, converted to
decimal, and written twice.
QU Quit Exit diagnostics mode
G0, G1, ....,GE, GF Get configuration
from memory page
Gets a memory page of configuration information
from the device.
S0, S1,...,SE, SF Set configuration to
memory page
Sets a memory page of configuration information
on the device.
To Next Page
Loading...
Need help?
General