Setup Records Supplemental Information
E-10
Baud Rate
The Device Server and attached serial device must agree on a speed or baud rate to use for
the serial connection. Use the following table to select Baud Rate settings:
Flow Control
Flow control sets the local handshaking methodfor stopping serial input/output. Generally,
flow control is not required if the connection is used to pass a blocked protocol with block
sizes less than 1k (ACK/NAK) and/or speeds of 19200 or less. Use the following table to
select Flow Control options:
Table E-7: Baud Rate Settings
Speed (bps) Hex
38400 00
19200 01
9600 02
4800 03
2400 04
1200 05
600 06
300 07
115200 08
57600 09
Table E-8: Flow Control Options
Option Hex
No flow control 00
XON/XOFF flow control 01
Hardware handshake with RTS/CTS lines 02
XON/XOFF pass characters to host 05
To Next Page
Loading...
