LCI SlimRack - Table of Contents

Rev: 03.19.21 Page 2 CCD-0004319
TABLE OF CONTENTS
Introduction 3
Safety 3
General Requirements 3
Resources Required 4
Component Descriptions 4
SlimRack Slide-Out Room Slide Rating Chart 4
In-Wall Slide-Out Chassis Specication 5
Slide-Out Congurations 5
In-Wall Slide-Outs 5
Recommended Wall Construction or Equivalent 6
Travel Trailer Lippert In-Wall 6
Fifth Wheel Lippert In-Wall 7
Supports on The Top of The Slide Room on The Main Frame Only 7
Upper Deck Slide Room Opening 8
Slide Room Opening Bottom Section 9
Square 10
Backers 10
Installation 12
Mechanical Components 12
Prepare Wall Opening For Slide Room Installation 14
Slide Room Installation 16
Specications 17
Visual Inspection For Tolerances 18
Electrical Components 19
Programming the Auto-Program 700156 or 697096 with Rocker Switch 20
Setting the Retracted Stop Point 20
Setting the Extended Stop Point 20
Pre-Operation Check 20
Operation 21
Prior to Moving the Slide-Out Room 21
Extending the Slide-Out Room 21
Retracting the Slide-Out Room 21
Auto-Program Motorized or Towable Controller 22
Electrical Override Mode 24
Auto-Program Motorized or Towable Controller 24
Manual Override Mode - Auto-Program Controllers 24
Alternate Override Modes - Auto-Program Controllers 25
Harness Connections For Auto-Program Motorized and Towable Controllers 27
Pinout Diagram For Motorized and Towable Controllers 28
Wiring Diagram For Auto-Program Motorized and Towable Controllers 29
Notes 30