LDARtools phx42 - Receiving After Shipping; Battery Charging Procedure

UNCONTROLLED IF PRINTED 9
Connecting the Probe
1. Snap the quick disconnect (A) into the probe port.
REMINDER: The probe and a probe tip filter must be connected to the phx42
before igniting the device.
Never operate the phx42 pumps without a filter in place. Do not remove the filter on a
running phx42 (unless performing filter detection calibration).
FAQ
Can I use an extension / other probe on the phx42?
Any device certified for use in hazardous environments using modern standards is done so
with accessories defined or attached. The phx42 was certified with the basic probe. You
should consult your safety department for a hazard assessment before using a different
probe.
Any extension should not exceed 20ft of tubing with minimum ID of 1/8”. The tubing in the
standard probe is 1/16” and cannot be used as a base for an extension probe. The extension
probe should utilize the same filters as the standard probe.
See Probe Integrity Inspection, Manual Calibration, Cal5.0 Manual for further instructions.
Why is the probe handle so heavy?
The probe handle was made from stainless steel to comply with the applicable safety
standards.
Preparing for Extension Probe Use
Whenever preparing for using an extension probe with your phx42:
1. Log in to the Customer Portal and click Unit Settings.
2. Locate the phx42 on the list and click the Edit icon.
3. Open the Multi Products tab and select Extension Probe.
4. Using the dropdown, change to Extension and enter the Probe length of extension from the tip of
the Probe Filter to the unit.
5. Click Save.
6. Next, use your Android tablet with the phxApp installed.
• Note: The tablet must have a network connection and be connected to the network.
7. Start the phxApp and connect to your phx42.
A