UNCONTROLLED IF PRINTED 10
Probe Care and Routing
When using the probe, a few basic points should be kept in mind:
8. Make sure the phx42 is oriented in the backpack so the hose can run straight out of the analyzer and
over your shoulder to avoid crimps and/or tears. Use the supplied D-rings to keep the hose in place.
9. When moving from place to place, the probe handle should be attached to the backpack to avoid
drops.
10. Avoid snagging or pulling on the probe hose.
11. Dropping the probe onto the filter could break the filter or cause leaks at the filter interface.
Use a Backpack Plate (LDAR#4207) to protect the connection to the phx42.
Disconnecting the Probe
1. Pull the collar on the quick disconnect to release probe.
2. Pull the probe off gently.
To Next Page
Loading...
