LDARtools phx42 - FAQs while Monitoring

UNCONTROLLED IF PRINTED 12
Power Button Indicators
The light pattern on the power button provides an indication of the machine’s state so that you can
give commands using the power button.
*Once the battery is fully charged but connected to a charger then it will cycle between
OFF/ON/OFF/ON and Breathing. This is because once the battery is fully charged it stops charging
(even though it is still plugged in) and the light goes OFF/ON/OFF/ON until the battery is depleted a
minimal amount and charging resumes, the light will then return to breathing.
Light Pattern
Ignited
Bluetooth Status
Charging
OFF/2 Pulses/OFF/2 Pulses
Yes
Discoverable
No
OFF/ON/OFF/ON*
No
Discoverable
No
Steady On (Solid)
Yes
Connected
No
ON/2 Pulses/ON/2 Pulses
(Solid/then flickering)
No
Connected
No
Breathing*
No
Either
Yes
No Light
Unit is Off.
Rapid Fast blink then OFF
Unit has detected a very low battery and automatically powered down.
In order to restart, you will have to attach the charger for at least 90
minutes before powering back on.