UNCONTROLLED IF PRINTED 33
Level 1 Repair Procedures
Please refer to the following procedures for all Level 1 repair procedures.
Antenna Upgrade
Battery Replacement
Battery Testing Procedure
Bluetooth Signal Strength Check
Broken Probe Tip Filter Removal
Glow Disk Replacement
phx42 v1 Probe Assembly
phx42 v1 Probe Disassembly
phx42 v2 Probe Assembly
Probe Integrity Test
Probe Testing Adapter Procedure
Pump Replacement (Combustion)
Pump Replacement (Sample)
Removing/Installing Enclosure Lid
Scrubber Media Replacement
Storage
When the phx42 is not in use for an extended amount of time the battery must be charged routinely to
maintain optimum battery performance. Charge for 12 hours every 90 days. Make sure to keep the H
2
above 400 psi. Every unit will leak down at its own rate. Experience with your machines will dictate
how often they will need recharging.
To Next Page
Loading...