UNCONTROLLED IF PRINTED 43
Comprehensive List of phx42 Skills
Normal Operations
1. Clean it
2. Power it ON/OFF
3. Know the end-of-day sleep mode procedure
4. Change Filter
5. Ignite it
6. Connect and Disconnect to the phxApp or your Monitoring Software
7. Fill H
2
8. Confirm that the H
2
Cap is in place
9. Attach unit to Charger
10. Confirm that the Charging Port Cover is in place
11. Take a PPM Reading
12. Initiate a self-check using the phxApp
13. Block the Probe tip during the self-check process
14. Calibrate using Cal5.0 (if applicable) AND Manually Calibrate
15. Report issues to LDARtools
16. Perform the Probe Integrity Inspection (weekly)
17. Initiate the Prepare-to-Ship Wizard
18. Receive it after shipping
19. Collect Inspection records with the Basic Survey Mode (optional)
20. Verify that you have most current version of phx42 Manual
21. Update the phxApp firmware
22. Set a PPM Alarm
23. Set a Response Factor other than 1
Level 1 Certified Operations
1. Troubleshoot issue with LDARtools Technical Support
2. Repair a Probe
3. Remove broken probe tip filter
4. Replace Scrubber filter media*
5. Replace the Glow Disk*
6. Replace the Battery*
7. Replace a Pump*
*Only after reporting an issue on the Customer Portal.
To Next Page
Loading...
