UNCONTROLLED IF PRINTED 19
phxApp
1. The phxApp can be downloaded from Google Play or obtained from your site’s IT department.
Starting the phxApp
1. Install the phxApp on an Android device with internet access.
2. Open the phxApp on your device.
3. Tap the phx42 device you want to connect to, then tap Connect to phx.
Note: You will need an internet connection the first time you connect to each phx42. Any
values specific to the unit are only updated during the “initialization” when the unit first
connects to the phxApp. If your goal is to update settings, you only need to “initialize.” If
you are already connected to the phxApp, and you need to update settings, you should
disconnect, and reconnect.
You will be directed to the phx42 screen once connection is complete.
An internet connection is required with the phx42 in the following scenarios:
1. When pairing with a new handheld device.
2. To update the unit settings (this should be requested by LDARtools support).
3. To perform a self-check and/or report an issue.
Scan or click the QR code for a video
demonstration of connecting to and
igniting your phx42 with the phxApp.
To Next Page
Loading...
