UNCONTROLLED IF PRINTED 29
phx42 Level 1 Repair Tech Pledge
• I will report an issue before doing any repair or replacement inside a phx42 case.
• I will report issues using the phxApp on an internet connection.
• I understand a log file is being recorded as soon as a phx42 is powered on. The machine does
not need to do anything other than power on.
• I will never turn on or run a phx42 pump without a probe filter in place.
• I will not use any part in or on a phx42 that was not provided by LDARtools.
• I will never use electrical tape, duct tape, soldering irons, wire crimps, or anything else not
provided by LDARtools to do a repair.
• I will not perform repairs that are not authorized by LDARtools.
• I understand that I am working on equipment that is full of H
2
and strapped to a person’s back.
• I will maintain an inventory of at least:
o 1 QTY – Sample Pump
o 1 QTY – Combustion Pump
o 2 QTY – Glow Disk Assembly
o 1 QTY – Scrubber Media Kit
o 1 QTY – v2 Probe Repair Kit
• I will perform weekly probe integrity inspections per the procedure in the phx42 user manual.
• I will perform the phx42 self-check at a minimum of once per month with the phxApp.
• I understand that failure to perform the self-check will greatly increase in field equipment
failures.
• I will immediately discard/recycle or return to LDARtools replaced parts.
• I will report my own issues, check my email for updates, and respond to the support case.
To Next Page
Loading...
