To Next Page

To Previous Page

Calibration

PHOTON

System Guide 28

DC Measurement for Offset Calibration

You will also be requested to measure the RMS value of the output at the

AC 10 Volt full-scale range and type it into the dialog box. Please make

sure that the voltmeter is switched to AC measurement. This

concludes the calibration of the OUTPUT channel.

AC Measurement for Gain Calibration

Questions and Answers:

Need help?

Do you have a question about the LDS Dactron PHOTON+ and is the answer not in the manual?

LDS Dactron PHOTON+ Specifications

General