Leader Electronics Corp. LV 5330 - Displaying the Color System; Selecting the Timecode Display Format; Setting the Backlight Brightness

5. System Settings
5-5
5.3.4 Displaying the Color System
To show or hide the color system, follow the procedure below. The color system is indicated
at the top of the screen as YCbCr, GBR, YGBR, RGB, YRGB, or COMP.
Procedure
SYSTEM → F•3 DISPLAY → F•1 INFORMATION → F•4 COLOR
Settings
ON: The color system is displayed (this is the default setting).
OFF: The color system is not displayed.
5.3.5 Selecting the Timecode Display Format
When you have set F•3 TIME to TIMECODE, follow the procedure below to set the
timecode display format.
Procedure
SYSTEM → F•3 DISPLAY → F•4 INFORMATION → F•5 TIMECODE
Settings
LTC: The LTC timecode is displayed.
VITC: The VITC timecode is displayed (this is the default setting).
5.3.6 Setting the Backlight Brightness
To set the backlight brightness, follow the procedure below.
Procedure
SYSTEM → F•3 DISPLAY → F•2 BACK LIGHT
Settings
HIGH: The backlight is lit brightly (this is the default setting).
LOW: The backlight is lit dimly. Use this setting in dark locations when the HIGH
setting feels too bright.