Need help?Do you have a question about the Leadshine ES-D508 and is the answer not in the manual?
Emphasizes verifying the power supply voltage range and correct polarity for connections.
Warns against setting excessively high current for small stepper motors to prevent damage.
Advises disconnecting the motor from its load before making motion direction adjustments.
Prohibits disconnecting motor leads while the power source is energized to prevent damage.
Details differential signal inputs and connection types (PNP/NPN) for pulse, direction, and enable signals.
Explains connecting to a PC using RS232 and the ProTuner software for drive configuration and control.
Details the 6-bit DIP switches on ES-D808/D1008 for setting microstep resolution and direction polarity.
Describes over-current, over-voltage, and position following error protections indicated by LED status.
Provides a table of common symptoms and their possible causes for diagnosing drive and motor problems.
Emphasizes verifying the power supply voltage range and correct polarity for connections.
Warns against setting excessively high current for small stepper motors to prevent damage.
Advises disconnecting the motor from its load before making motion direction adjustments.
Prohibits disconnecting motor leads while the power source is energized to prevent damage.
Details differential signal inputs and connection types (PNP/NPN) for pulse, direction, and enable signals.
Explains connecting to a PC using RS232 and the ProTuner software for drive configuration and control.
Details the 6-bit DIP switches on ES-D808/D1008 for setting microstep resolution and direction polarity.
Describes over-current, over-voltage, and position following error protections indicated by LED status.
Provides a table of common symptoms and their possible causes for diagnosing drive and motor problems.
General| Control Modes | Position, Speed, Torque |
|---|---|
| Feedback | Incremental encoder |
| Input Voltage | 20-50 VDC |
| Output Current | 0 ~ 8.0A |
| Protection Features | Over-voltage, Over-current, Over-position error |
| Pulse Input Frequency | 200 kHz |
| Insulation Resistance | 100 MΩ min |
To Next Page
